Download Center
ideaMaker
ideaMaker 3.4.2 versions. Please report to help.raise3d.com if you encounter any problem.
|
Windows |
Mac |
Linux 32-bit |
Linux 64-bit |
|
Version 3.4.2 Jun 24, 2019 |
Version 3.4.2 Jun 24, 2019 |
Version 3.4.2 Jun 24, 2019 |
Version 3.4.2 Jun 24, 2019 |
| .DEB | .AppImage | .DEB | .AppImage |
ideaMaker Release Notes
View All Versions
ideaMaker Manual
System Requirements:
- Microsoft Windows XP or later, 64-bit recommended
- Mac OS X v10.7 or later, 64-bit only
- Ubuntu 14.04 or later
- 2GB of RAM, 8GB or more recommended
- OpenGL 2.0-capable system
- Intel® Core 2 or AMD Athlon® 64 processor; 2 GHz or faster processor
- 2.0 GB or more of available hard-disk space
- 1280 x 800 display with 32-bit color and 512 MB or more of dedicated VRAM
——————————————————————————————————————————————————————————————————————
Quick Start Guide
|
Pro2 Series |
N2/N2 Plus |
N1 |
|
Pro2 Series Quickstart Guide 9.01 MB |
N2/N2 Plus Quickstart Guide 4.23 MB |
N1 Quickstart Guide 2.24MB |
RaiseTouch
Download and put the file at root directory of a FAT32-formatted USB 2.0 Flash Drive or SD card. (Do not modify the file name) Then reboot the machine to apply the lastest update:
——————————————————————————————————————————————————————————————————————
Motion Controller Board Firmware
Download and put the file in USB or SD card. Select the firmware file and press ’OK’ to update.
Pro2 Series
0.0.66
541KB
(Pro2 Series Only- do not install on N Series!)
Please note that these firmwares are NOT for the filament run out sensor add-on.
Please go to this page for instruction and firmwares.
https://www.raise3d.net/pages/filament-run-out-sensor-installation-instruction
|
N1-Dual |
N2-Dual |
N2 Plus-Dual |
|
1.1.6-rev1 343KB |
1.1.6-rev1 343KB |
1.1.6-rev1 343KB |
| --------- | ||
|
N1-Single |
N2-Single |
N2 Plus-Single |
|
1.1.6-rev1 333KB |
1.1.6-rev1 333KB |
1.1.6-rev1 333KB |